Abstract
ABSTRACTSince its introduction in the late 1950s, hydraulic vibrators have become the dominant source for land seismic surveys. The hydraulic vibrators typically used for commercial land seismic acquisition, however, are large, costly to operate and expensive to purchase. This inhibits their use for small‐scale and short‐duration surveys as well as Vibroseis research. In this paper we describe, in detail, the construction of a portable vibrator from commercially available components for a cost of less than $US2,000. Data shows that the vibrator is able to successfully transmit sweeps from 15 to 180 Hz with different spectral contents. The vibrator produces a stronger signal than a sledgehammer and we estimate its output to be around 1 kN. The frequency content of the data was concentrated at lower frequencies (<100 Hz) and the ground‐roll was far more energetic than that produced using a sledgehammer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
