The characterization of microporosity in a ploughpan by submicroscopic and quantimet techniques

Abstract

Ploughpans are usually recognizable in thin sections because of their massiveness (density) when compared with adjacent parts of the soil. When pores can be measured in the ploughpan such massiveness can be documented and compared with the porosity of the underlying soil profile. Such measurements, however, concern only meso- and macropores when done by Quantimet on micrographs obtained with the light microscope. This is due to the thickness of the thin section and the necessity to work with transmitted light. The measurement of the smaller mesopores may also be problematic with the light microscopy—Quantimet technique. The introduction of backscattered electron scanning images allows to obtain micrographs of a very thin layer and this made it possible to measure micro- and mesopores by Quantimet. If only small magnifications are used, macropores can also be measured. In the present investigation, micro- and mesopores were quantified by a combination of backscattered electron and Quantimet techniques and the macropores by light microscopy and Quantimet. It was demonstrated that macro- and mesopores were less frequent in a ploughpan than outside, whereas capillary or micropores increased somewhat.