Abstract
AbstractTransmission electron microscopy (TEM) can be used as a precision characterization tool to identify very small precipitates in diffusion aluminide coatings. However, in order to successfully prepare the appropriate samples for TEM observation, often non‐traditional thin film preparation techniques need to be employed. In this work, two sample preparation methods of twin jet electro‐polishing and ion milling were experienced to characterize fine precipitates (< 1 μm), in Si‐aluminide coatings applied on Ni‐base superalloy In‐738LC by slurry technique. These precipitates are concentrated throughout the topcoat zone. It was found that the preparation of thin film exactly from the outer zone of the coating is only possible using ion milling process. The ion‐milled specimens were utilized to observe by JEOL high resolution TEM operating at an accelerating voltage of 300 kV. Electron diffraction patterns, bright field and EDS were used to identify the precipitate phases as well as the coating matrix. The results showed that the fine precipitates are typically chromium silicides in nature, mostly as Cr3Si and CrSi, distributed in the β‐NiAl matrix phase.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
