Abstract
The methods of hardening of the chaff-cutter drum knives in a grain harvester combine are analyzed. The wear resistances of 65g steel samples hardened by quenching and borating and heating by high-frequency currents are compared. The results of field tests of the hardened knives are presented. These results are used to propose a design for a hardening coating. A two-coil induction heater is suggested for simultaneous heating of both face edges of a knife.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
