Abstract
Tapping process in Computer Numerical Centre, is a key for the process because of its difficult to hold the close tolerance. During this study different types of tapping tool manufacturer have taken with same tapping tool material specification for the consideration. And also to find the relationship between the previous operational performances with tool and its parameter influence in the computer numerical control system has also taken for the consideration. During drilling process the new drill bit (drill bit 4) have higher tool life than the regained tool bits (Drill bit 1, 2 & 3). During tapping process, Emuge tool 2 and Emuge tool 3 have has higher production rate such as 434 and 356 components respectively. This Emuge tool 2 and tool 3 have previous working tool in the drilling process is drill bit 4 (New Drill Bit). Which has improved the surface roughness than the other drill bit. Due to reduced surface roughness causes the taping tool to ease in there processing which resulted in the higher production rate in tapping tool than the other conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
