Tailoring microstructures of carbon fiber reinforced carbon aerogel-like matrix composites by carbonization to modulate their mechanical properties and thermal conductivities

Abstract

The microstructure evolution of carbon fiber reinforced carbon aerogel-like matrix (C/CA) composites with carbonization temperature and its influence on their properties were investigated. The removal of residual organo-functional groups of the C/CA precursors is dominant when carbonized at 600–750 °C with a large volume shrinkage difference by 17–22% as compared to that at 1200 °C, while the rearrangement of novolac structures is dominant at 900–1200 °C with a slight volume shrinkage fluctuation of 6%. Resultantly, the amount of micropore first increases and then decreases, while the particle size experiences an opposite change. The microstructure correspondingly transforms from a completely amorphous state to a partially amorphous state with graphite crystallites in low-angle misorientation, and then with graphite-like entangling ribbons. Due to the reduced residual tensile stress and increased interfacial bonding, the resulting composites with a variable bulk density of 0.58–0.64 g cm−3 have much higher compressive strengths of 45.8–96.9 MPa than other reported carbon foams or aerogels with similar bulk densities. The increase of strength and modulus with carbonization temperature is mainly due to the smaller tensile stress, higher particle packing compactness, larger microcrystallite size and less residual organo-functional groups. The composites also present a relatively low thermal conductivity of 0.12–0.59 W m−1 K−1. The increase of thermal conductivity with temperature is related to the synergistic effect of reduced phonon scattering associated with smaller specific surface area, larger microcrystallite size and less organo-functional groups and improved phonon transfer associated with increased inter-particle contact area.