Systematic reorientation of diamagnetic fabrics of Taunus quartzite due to experimental impact cratering

Abstract

Systematic reorientation of diamagnetic fabrics of Taunus quartzite due to experimental impact cratering Sonal Tiwari1, Amar Agarwal1, Thomas Kenkmann2, Michael H. Poelchau21Department of Earth Sciences, Indian Institute of Technology-Kanpur, Kanpur – 208016, India.2Geology, University of Freiburg, 79104 Freiburg, GermanyCorresponding author´s email: sonaljp20@iitk.ac.inAbstractPara- and ferromagnetic fabrics are known to provide essential clues for understanding impact cratering processes. However, research on the effects of shock waves on diamagnetic fabrics is lacking. We, therefore, conducted a hypervelocity impact experiment on a block of diamagnetic Taunus quartzite and studied the changes in diamagnetic fabrics. Taunus quartzite was formed by a low-grade Variscan metamorphism that overprinted a 405 Ma old sandstone. It consists of c. 91 vol % quartz and a fine-grained, greenish phyllosilicate-bearing matrix (c. 8 vol %), along with small amounts of rutile, chromite, zircon, monazite, and iron oxides.The experiment was carried out on a 20 cm Taunus quartzite cube with a two-stage light-gas gun of the Fraunhofer Ernst-Mach Institute for High-Speed Dynamics (EMI) in Freiburg (EMI), Germany. The gun has a 8.5 mm calibre launch tube. The 0.3690 g basalt sphere projectile was accelerated to 5.457 kms-1, with a target chamber pressure of 1.2 mbar. The projectile diameter (dp) was 6.18 mm. Later, 14 mm-diameter nonmagnetic diamond bits were used to drill oriented cylindrical cores from unshocked and shocked Taunus quartzite blocks.  The AMS of the unshocked and shocked specimens was determined at room temperature in KLY-4S Kappabridge (AGICO). Following the AMS measurements, the cylindrical specimens were cut to make thin sections, which were studied under a Leica DM4 scanning optical microscope.Hypidiomorphic grain texture, serrated grain boundary, grain boundary migration, ataxial veins, Boehm lamellae, and recrystallized quartz represent the natural microscopic features. Impact-induced microstructures include trans- and intragranular microfractures. Our AMS results demonstrate that in the crater subsurface, the reorientation of the diamagnetic fabrics is concentrated in a zone of ~4 projectile diameters (25 mm) width directly below the point of impact. Higher reorientation in this zone indicates the concentration of damage. The damage is concentrated directly below the point of impact. Another important observation is that weak shock waves have caused an increase in the bulk susceptibility. These results, thus, show that the changes in diamagnetic fabrics can be used as a proxy for plastic deformation caused by shock waves at low peak pressures.Figure. The images show the specimens' position (black dots), the point source (brown dot), the impact crater (brown arc), and the variation in the orientation of k3.