Abstract
Fly ash is a solid waste discharged from thermal power plant. Specific surface area of floating fly ash cenospheres (FACs) would increase after it was modified. The photocatalytic composite of TiO2/FACs was successfully synthesized by sol-gel method using the carrier of modified FACs and tetrabutyl titanate as starting materials. The different influence factors on the photocatalytic performance of TiO2/FACs composites were characterized through SEM, EDS, XRD, UV-vis DRS and BET surface measurements. The UV-vis DRS spectra revealed that the absorption edge of TiO2 is 387 nm while that of TiO2/FACs photocatalysts red-shifts to 500 nm. Photocatalytic activity of TiO2/FACs was evaluated by the photocatalytic depigmentation of methyl orange solution (MO, 20 mg L-1, pH = 6.3) under visible light irradiation. It was found that the specific surface area, surface roughness and activity of FACs were increased by NaOH solution activation. The degradation rate of MO reaches 52% in 180 min under the visible light illumination. But too much FACs could decrease its photocatalytic activity and degradation rate. And the recovery test indicated that TiO2/FACs photocatalyst was rather stable, easy to recover from the treated wastewater.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.