Abstract
Dynamic-mode atomic force microscopy (DFM) combined with Kelvin probe force microscopy (KFM) has been a powerful tool not only for imaging surface topography but also for investigating surface potential on a nanometer-scale resolution. We have developed DFM/KFM using a microfabricated cantilever with a lead zirconate titanate (PZT) piezoelectric thin film used as a deflection sensor. The observed sample can be in a completely dark environment because no optics are required for cantilever deflection sensing in our experimental setup, which is also equipped with a mechanism to irradiate ultraviolet (UV) light onto the sample. We prepared a platinum-on-silicon substrate and deposited fullerene-derivative (PCBM; [6,6]-Phenyl-C61-Butyric Acid Methyl Ester) film patterns by vacuum evaporation with two shadow masks in crossed directions. The energy band diagram with band-bending, it was created by simultaneously obtaining topographic and surface potential images of the same area using the developed DFM/KFM. [DOI: 10.1380/ejssnt.2015.102]
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
