Abstract
A new damping method was developed not only as a testing tool to investigate in situ deformation under stress, but also as a processing method to superplastically deform ceramics. The specific damping capacity (SDC) at low frequencies (<0.2 Hz) decreased with increasing frequencies, which matched previous internal friction results. However, at higher frequencies (0.2–5 Hz) SDC increased with frequencies, which was explained by a new internal frictional heat mechanism. Three different ceramics: a non-superplastic one and two superplastic ones with different activation energies, showed the same behavior at the high frequency damping tests (1–5 Hz). From these results, it was deduced that a cyclic load at high frequencies, superimposed on a static one, has a great potential to enhance superplasticity by specifically heating up grain boundaries from internal frictional heat.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
