Abstract
Many manufacturing processes, e.g. casting, forging, moulding, require that components must have a sufficient draft angle. Ensuring this when using general B-spline surfaces is a difficult task, often requiring iterative modeling. In this paper a theorem is presented that provides sufficient conditions to ensure draft angle on B-spline surfaces. The theorem is used to develop a simple algorithm that was used to add a draft angle to two surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
