Abstract
AbstractThis study was conducted to improve the adhesion strength between a propellant, liner, and heat‐resistant material. As the drying time of the heat‐resistant material increased, the adhesion strength between the propellant, liner, and heat‐resistant material improved. Further, the surface of the heat‐resistant material was subjected to buffing treatment to improve the adhesion strength. In addition, as the thickness of the heat‐resistant material increased, the adhesion strength degraded. Moreover, the adhesion strength was improved by increasing the thickness of the liner on the heat‐resistant material. Besides, the adhesion strength slightly reduced with an increase in the plasticizer content. The liner curing time was an important factor affecting the adhesion strength, and an optimum liner curing time was obtained. In this study, the adhesion strength was improved by applying a barrier coat between the heat‐resistant material and liner. The adhesion was further improved when the heat‐resistant material was buffed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
