STUDY ON MECHANICAL PROPERTIES OF TOTAL KNEE ARTICULAR CARTILAGE UNDER DIFFERENT LOADING RATES

Abstract

Knee joint is the main weight bearing tissue of human body, also it is one of the prone parts of the clinical disease. Under different sports conditions, knee joint was loaded at different forms. In this study, the changes of average contact pressure, peak contact pressure, contact area and pressure-sharing regions were researched using the intact and defect pig knee joints under different loading rates and loads, including fast rates and large loads. These data were measured and recorded by usage of the sensor plate that placed between the unilateral meniscus and the femur cartilage during loading process. As for the intact cartilage samples, the average contact pressure and peak contact pressure of the femur cartilage increase with the loading rate, while the contact area is contrast to it. As for defect cartilage samples, it not only emerged stress concentration on the edge of the defect and pressure distribution in joint cavity was different with intact cartilage samples, but also the main bearing region was transferred from the femur cartilage-meniscus contact area to the femur cartilage-tibial cartilage contact area at different loading forms. In different loading stages, the pressure-sharing regions between the cartilage and the meniscus also changes. Different loading rates, different loads and defects will change the mechanical states of the knee joint. In loading forms, the mechanical condition may cause or aggravate damnification of the knee joint cartilage. Therefore, this study is beneficial for promoting and perfecting the research of mechanical properties of knee joint cartilage and provides a theoretical basis for the prevention and treatment of knee cartilage injury.