Abstract
With the popularization of 3D printing technologies, it is now possible to develop patient specific simulators and various other accessories using this technology in medical physics and dosimetry. This work aims to evaluate the electronic equilibrium of 3D printed phantoms using PLA and ABS filaments compared to PMMA for 137Cs gamma rays using OSL dosimetry. A Landauer microStar ii commercial OSL system was commissioned and it was used nanoDot dosimeters. Phantom plates with 2.5, 3.0 and 5.0 mm thickness were used to obtain electronic equilibrium for 137Cs gamma rays. Measurements were compared with PMMA measurements at standard conditions. Results show that measurements with ABS and PLA thicknesses of 2.5 and 3.0 mm presents dosimetry results within irradiation uncertainty. More accuracy is obtained using 3.0 mm for both PLA and ABS phantoms, with differences in less than 0.5%. It can be concluded that PLA and ABS 3D phantom plates has similar properties of PMMA for 137Cs gamma rays dosimetry and can be used for developing dosimetry accessories for this energy photon beam.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
