Abstract
The effects of heat treatment and initial microstructure on tensile properties of 22MnB5 and 30MnB5 high-strength hot stamping steels with martensite-ferrite matrix were investigated. Hot stamping steels possessed limited elongations of about 5% in a tensile strength ranging from 1300 to 1500 MPa when quenched at temperatures above A3 temperatures. The total elongations were tried to improve by partial austenization between Ac1 and Ac3 temperature and quenching. Ac1 and Ac3 temperatures were calculated via ThermoCalc. Microstructural characterization was made by using Light Microscope and Scanning Electron Microscope. Microstructure is composed of ferrite+martensite. It was seen that annealing temperature affects the volume fraction of phases. It was concluded that initial microstructure is an important parameter for the final microstructure. This method can be used for automobile parts which require higher TE with sufficient yield and tensile strength. Also this process may be a way of using Zn coated steel sheets in hot stamping process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.