Abstract
The results of mathematical modeling of the melt movement in the working volume of tundish of continuous-casting machine a capacity of 50 tons are presented when changing the type of flow modifiers used and methods of argon injection, which have a decisive effect on the hydrodynamics of the bath and the formation of dead zone that determine the quality parameters of the cast blanks produced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Blanking productions in mechanical engineering (press forging, foundry and other productions)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
