Abstract
AbstractThe relationship between wetting and pressure‐sensitive adhesion was studied using an adhesive composed of poly(butyl acrylate) and various adherends of different surface tension. The amount of adhesive deposit was determined quantitatively by tracer technique although the unbonding process was apparently observed as interface failure. The adhesive force and amount of deposit were both dependent on the critical surface tension of the adherends. Maximum tack value and contamination were observed with adherends whose critical surface tension was close to that but a little higher than that of the adhesive. The adhesive force obtained was lower than cohesive strength of adhesive. From this evidence, a mechanism for pressure‐sensitive adhesion was discussed: the bond breaks in the addesive mass around the very minute spots where interaction is at work between adhesive and adherend. Inasmuch as the density of the minute spots per unit area depends on the surface tension, the adhesive force also depends on the surface tension.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
