Abstract
The limiting loads for scoring of three kinds of hypoid gears, which have different dimensions and are produced by different methods, are tested and compared with each other. Then the effects of surface treatments on the limiting loads for scoring of hypoid gears were tested and compared with the results of spur gears and roller tests. From the test results, it was made clear that the contact conditions of the test surfaces affect the limiting load for scoring. Further the frictional losses of hypoid gears were measured. The results show that the coefficient of friction of hypoid gears does not change by the kind of hypoid gears, but it depends upon their sliding velocities, and their empirical formula was obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
