Abstract

Previously published results on electrical and mechanical properties of BaTiO3 coatings prepared by atmospheric plasma spraying showed anomalies in their dielectric response. This paper provides a study of electrical and mechanical properties of BaTiO3 coatings after thermal posttreatment. The spraying was carried out by a direct current gas-stabilized plasma gun. BaTiO3 was fed into the plasma jet as a feedstock powder prepared by reactive sintering of micrometer-sized powders of BaCO3 and TiO2. In the next step the coatings were annealed in air. Microstructure and phase composition are reported and discussed in relation to electric and mechanical properties. Dielectric properties are reported for the radio frequency (RF) range.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.