Stress of tooth and PDL structure created by bite force.

Abstract

Stress is created by the bite force and distributed along the tooth towards the PDL structure. It is of interest to investigate the complex tooth structure, consisting of enamel, dentine, pulp, and thin cementum layer and how it functions in stress distribution. This study was intended to analyze the role of the tooth and PDL structures in stress distribution, by using a three-dimensional finite element method. A mandibular first molar was constructed for the finite element model. The bite forces were measured by Pressensor, and these bite force values were programmed to load down upon the occlusal surface of the model. The results were expressed by stress contours and principal stress graphs. The stress was found to decrease as it distributed from the occlusal surface towards the cervical portion in the dentine and the pulp. In contrast, the stress, especially a compressive stress, increased gradually in the enamel layer in the lower half of the crown, in the same direction. It was apparent in displayed pattern of stress that the stress distributed outward towards the surrounding portion of the lower half of the crown. This resulted in a uniform magnitude of the principal stresses for all aspects of the mesial and distal roots. The stresses of both roots were generally compressive stress. When comparing the stress values of sampling points positioned between the root surfaces and the periphery of the PDL (the alveolar wall), all principal stresses for those of the PDL (periodontal ligament) were less than those of the root surfaces. These findings revealed that the PDL, the dentine, and the pulp functioned in cooperation in stress reduction; and the sequences of enamel, dentine, and pulp influenced the pattern of stress distribution. The different material properties of the tooth structure in sequence was considered a very important factor for stress reduction and for the pattern of stress distribution, especially in the root.