Abstract
Stencil printing for flip chip packaging using fine particle solder pastes is a low cost assembly solution with high throughput for fine pitch solder joint interconnects. The manufacturing challenges associated with both solder paste printing increases as electronic device size decreases due to trend of miniaturization in electronic components. Among multiple parameters, the two most important stencil printing parameters are squeegee pressure and printing speed. In this paper, the printing behavior of Pb free Sn-3Ag-0.5Cu solder paste with a particle size distribution of 2–12 μm for wafer level bumping using a stencil printing method (stencil opening dimension −30 μm) was evaluated by varying the printing speed and squeegee pressure to fabricate solder bumps with a sub 100 μm size. The optimal squeegee pressure and print speed for the defect free printing behavior and fairly uniform size distribution of reflowed paste were found to be 7 kgf and 20 mm/s, respectively. The average size of the reflowed printed paste decreased with the increasing squeegee pressure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
