Abstract
This paper deals with the Static and Modal analysis of the triple layer two stacked flexure bearing.In our previous papers, we have deal with the double stack double layer static and frequency analysis. There is less data available for the designer to choose desired bearing for desired output and hence more simulations are made and are presented graphically in this paper. The models were prepared in CATIA and were simulated in ANSYS software. After laying the boundary conditions, the results were obtained, and some results were validated by comparing them with previous obtained results in research papers. A design procedure is laid for designer to choose the optimum combination for the desired output.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.