Abstract
Background: Stacked screws is a commonly used technique in single-stage revision anterior cruciate ligament (ACL) reconstruction in the setting of bone loss, but there are limited data to support its use. Hypothesis: Two configurations of a biocomposite stacked screws construct have similar fixation strength and linear stiffness as a primary ACL reconstruction construct in a biomechanical model. Study Design: Controlled laboratory study. Methods: A total of 30 porcine legs were divided into 3 groups. Group 1 underwent primary ACL reconstruction with a patellar tendon graft fixed into the femur, with an 8-mm biocomposite interference screw of beta-tricalcium phosphate and poly lactide-co-glycolide. For a revision ACL reconstruction model, groups 2 and 3 had bone tunnels created and subsequently filled with 12-mm biocomposite screws. New bone tunnels were drilled through the filler screw and the surrounding bone, and the patellar bone plug was inserted. Group 2 was fixed with 8-mm biocomposite screws on the side of the graft opposite the filler screw, while group 3 had the interference screw interposed between the graft and the filler screw. The construct was loaded at 1.5 mm/s in line with the tunnel until failure. Load to failure, linear stiffness, and mode of failure were recorded. Results: The mean pullout strength for groups 1, 2, and 3 was 626 ± 145 N, 653 ± 152 N, and 720 ± 125 N, respectively (P = .328). The mean linear stiffness of the construct in groups 1, 2, and 3 was 71.4 ± 9.9 N/mm, 84.1 ± 11.1 N/mm, and 82.0 ± 10.8 N/mm, respectively. Group 2 was significantly stiffer than group 1 (P = .037). Conclusion: Two configurations of a biocomposite stacked screws construct for a single-stage revision ACL reconstruction in the setting of bone loss show a similar fixation strength and linear stiffness to a primary ACL reconstruction at time zero in a porcine model. Clinical Relevance: In the setting of bone loss from tunnel malpositioning, a single-stage revision ACL reconstruction using a stacked screws construct may provide adequate fixation strength and linear stiffness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.