Solid phase extraction for GC-FID determination of 3,4-methylenedioxymethamphetamine (MDMA), 3,4-methylenedioxyamphetamine (MDA) and methamphetamine (MA) in human urine

Abstract

A simple solid phase extraction method was developed for estimating the amounts of 3,4-methylenedioxymethamphetamine (MDMA), 3,4-methylenedioxyamphetamine (MDA) and methamphetamine (MA) in urine by using the GC-FID technique. The urine sample was alkalinized prior to undergoing solid phase extraction using Oasis HLB®. A 5% methanol-water mixture containing 2% ammonium hydroxide was used for washing, whereas a 70% methanol-water mixture containing 2% acetic acid was used for elution. The compounds were analyzed using the standard GC-FID conditions previously established for ecstasy samples, i.e., column: CP-SIL 24 CB WCOT (30 m × 0.32 mm i.d., 0.25 μm film thickness); carrier gas: N2 (2.6 mL/min); injector temperature: 290°C; detector temperature: 300°C; oven temperature: initial 80°C, final 270°C (1 min), ramp rate 20°C/min. Validation demonstrated the linearity of the calibration curves between 1 and 20 μg/mL (r > 0.99) for all analytes. The precisions (% RSD) were approximately 3–17%, 6–16% and 7–17% for MDMA, MDA and MA, respectively. The accuracies (% DEV) were (−)17-(+)5%, (−)18-(+)15% and (−)18-(+)0.6% for MDMA, MDA and MA, respectively. The recovery ranged from 80 to 107% and the lower limit of quantification (LLOQ) was 1 μg/mL. The method was successfully applied to determine the levels of these compounds in the urine of drug abuse suspects.