Abstract

ABSTRACTWe report on the successful patterning of polyamic acid over wide areas using 28 kV pulsed electron beams produced in 30 mTorr air. The pattern degradation during the 350°C, 1/2 hr, imidizing thermal cure is prevented by pulsed, flood electron beam hardening of the developed polyamic acid patterns using the same soft vacuum, pulsed electron beam apparatus. It is also shown that a CW, low voltage, 1 to 3 kV electron beam sustained oxygen discharge can be used to completely strip the hardened, imidized material which is difficult to remove by wet methods. We also present, dose versus thickness remaining characteristics as a function of electron source to substrate distance and some examples of polyimide patterning.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.