Abstract
Slope stability has been a problem that studied on geotechnical works for the uncertainties such as varieties of soil behaviours to unpredicted failure of measurements and samplings. The Limit Equilibrium Method (LEM) has been popular for decades for its convenience but cannot determine displacement thus the result could be uncertain. As computational calculations have been developed, the Finite Element Method (FEM) began to use as a tool to not only determine factor of safety, but also determine displacement and forces that affect slope’s stability. This research was done to analysed slope stability using Shear Strength Reduction (SSR) and compared it to general method such as Limit Equilibrium Method (LEM). The research was conducted on a section in Sadawarna DAM ring road area, Subang, West Java. Slope on research area was divided into two layers with the bottom layer relatively non-cohesive compared to the top of layer. Both soil however dominantly consist with fine grain soil such as silt and clay. The upper layer of slope can contain more water with liquid limit of 73,46% compared to the lower layer with 68,27% liquid limit. Simulation result showed slope that analysed using SSR method has Factor of Safety (FoS) 0,12 lower than LEM method. SSR method could be used to analysed pessimistic value at worst scenario and could predicted deformation of slope.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Geological Sciences and Applied Geology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.