Single-Phase Split-Inductor Differential Boost Inverters

Abstract

In this paper, two single-phase single-stage split-inductor buck–boost inverters are proposed: type-I and II. The proposed type-I is unity power factor inverter, while the proposed type-II inverter is suitable for any power factor. Both topologies remove the shoot-through problem. Furthermore, the reverse recovery issues for all switches are eliminated; therefore, mosfet s are used to obtain higher efficiencies. The proposed inverters operated at higher switching frequencies confer the additional benefit of smaller passive components. The current stresses of the two switches in the proposed type-I and II inverters are lower of the conventional boost inverter. The dead time can be eliminated at both the high and line switching frequencies. In addition, the inductor conduction loss is minimized to improve efficiency. Moreover, the voltage stresses of the two switches in the type-I inverter can be much lower of its counterpart boost inverter. Most importantly, unlike the conventional high-reliability inverters, the magnetic volume of the proposed high-reliability type-I and II inverters is same of its counterpart boost inverter. The experimental results obtained for 500 W, 110 Vrms, 60 Hz hardware prototypes verify the analysis.