Abstract
Out of autoclave composite manufacturing is a process that achieves same quality as an autoclave process but through different method and one of them is thermoforming process in which, it can save the process cost and time. Recently, the fabrication process to fabricate thermoplastic composites by using thermoforming method becoming more popular among the thermoplastic research area. The simulation process is applied to enable the prediction of defects as well as to study the behavior of the process at early stage using simulation analysis to avoid trial and error during fabrication. To simulate the simulation, there are several factors and parameters need to be considered so that the defects could be avoided due to the excellent and poor formability will be linked between the fabricated samples in Aniform and the manufactured products. In this study, Two-Folded Clip panel mold type has been chosen to simulate the fabrication process. The results show the tensioner of AUY-50 is the best tensioner to be used in this research due to the significant of the result of press formed laminate quality with no voids appeared.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
