Short-length nanosecond pulsed 1.653-μm DBR fiber Raman laser oscillator fabricated by femtosecond laser direct-writing

Abstract

We demonstrate a nanosecond pulsed 1.653-μm fiber Raman laser (FRL) oscillator in a short-length distributed Bragg reflector (DBR) cavity made by femtosecond laser direct-writing technique. The DBR FRL cavity is composed of commercial ultrahigh NA germanium-doped silica fiber with a short length of 10 m and a pair of fiber Bragg gratings (FBGs). The FBGs were directly inscribed on the ends of the Raman gain fiber, using femtosecond-laser point-by-point (PbP) writing method. A home-made 1.55-μm nanosecond fiber laser source was used as the pump of the FRL. 1.653-μm nanosecond pulsed laser oscillation with maximum average output power of 125 mW (corresponding to peak power of 6.6 W), 3 dB linewidth of ≤ 0.15 nm, and slope efficiency of 48 % was obtained under 1.55-μm pump with optimized repetition rate of 10 MHz. The optical signal-to-noise-ratio (OSNR) of the 1.653-μm narrow-linewidth Raman lasing is above 70 dB. The short-length DBR FRL output exhibits decently high degree of polarization (DOP) and high degree of linear polarization (DOLP) above 80 % in 3-hour period, benefitted from the birefringent FBGs made by femtosecond laser direct-writing method. It is expected that by further reducing the cavity length to < 1 m, the 1.653-μm DBR FRL oscillator made by femtosecond laser direct-writing method is promising as single-frequency narrow-linewidth, highly linearly polarized, high-OSNR laser sources for high-sensitivity CH4 gas detection.