Semi-outdoor filterless air purifier for smog and microbial protection with water purifier system

Abstract

PurposeAir pollution and COVID-19 problems are being increasingly scrutinized. This article discusses the optimum design of an indoor and semi-outdoor air purifier, using a water-based filtration system. MethodsAn air purifier was fabricated, then comparison of purifying efficacy of the system between untreated air and using an air pump was done. Incense smoke was generated within a room for 10 seconds. The number of particle sizes of PM0.3, PM0.5, PM1.0, PM3.0, PM5.0, and PM10 μm (particle/ m3) as well as the detection of mass concentration of PM1.0, PM2.5, PM5.0, and PM10 (mg/m3) at 0 and 5 min were recorded. Each experiment was repeated 10 times. ResultsParticles in untreated air, except PM10, showed the maximum increase rate of the number of particle sizes greater than the air pump experiment. The highest differentiation between two methods was that PM1.0 and PM0.5 of untreated air increased to 113.647 and 61.539 % whereas the air pump method showed 4.720 and 2.533 %, respectively. The PM mass concentration of untreated air increased from 50.217 to 51.167 % while the increased rate of PM using an air pump was 2.784 to 2.902 %. ConclusionThis study proposed a water-based air filtration technique, which can reduce the level of particulate matter, and also is a low-cost prototype. For the next experiment, the study should extend test length, clarify an optimum ratio of disinfectant technologies, connect with the internet of things, compare the efficiency with a HEPA filter air purifier, and then also measure some particles which are smaller than 0.2 μm.