Abstract

The vibration control of rotors is often performed using elastomeric or fluid dampers together with rolling element or hydrodynamic type bearings. Electromagnetic dampers seem a valid alternative to conventional solutions and also to active magnetic bearings (AMBs) because their simpler architecture, size and, if of transformer type, also for the absence of power electronics, position sensors, and any fast feedback loop. However, transformer eddy current dampers require a constant voltage power supply than can be provided by an embedded generator to reduce cost and improve the reliability. The present paper proposes a self-powered damper to fulfill these requirements. A three-phase permanent magnet electric generator (connected to the rotating shaft) generates the required power for the damping device. The generator is connected to the damping circuit by means of tuned impedance and a three-phase rectifier.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.