Abstract
The research given in the article is devoted to the selection of the electric motor of the hydraulic press drive with a nominal force of 5MN. The article presents the main characteristics, a description of the operation of the press using the means of mechanization of the technological process of pressure treatment. When using the Deform-3D software package, a simulation of the stamping process of the ZIL 130 cardan shaft crosspiece was carried out. Based on the presented hydraulic scheme of the press, its topological model is formed in the PA-9 software package. The deformation force obtained during the simulation of the stamping process was used in the topological model of the press. With the help of a tabular cyclogram, the sequence of actuation of the final switches and hydraulic distributors during the stamping process is given.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
