Abstract
An ultrasonic finishing treatment unit was used for experimental researches to find effective burnishing modes. Based on the research findings of an obtained surfaces microtopography the following parameters were determined: Ra – arithmetical mean deviation of the profile and Pc – average number of profile end points per 1 cm of the surface length, by which the quality of treatment was evaluated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
