Abstract
In this paper, we will present the stratigraphic evolution, internal facies architecture and geomorphology of the Middle Pleistocene Emme delta, controlled by rapid high-amplitude lake-level change. The Emme delta was deposited on the northern margin of glacial Lake Weser, located in north-west Germany. Rates of lake-level rise were probably >50 mm year−1 and rates of lake-level fall 30–50 m within a few days or weeks, due to the opening of lake outlets. We use digital elevation models, sedimentology and shear wave seismics to improve earlier reconstructions and investigate the influence of rapid base-level change on delta development. Shear wave seismic data resolve architectural elements in the range of metres and bridge the common gap between outcrop and conventional compression wave seismic data. The radial delta complex is about 2 km long, 1.8 km wide and up to 70 m thick, overlying a concave, up to 13° steep dipping ramp surface. It consists of vertically and laterally stacked delta lobes, caused by lobe switching during base-level change. During the lake-level rise, vertically stacked (Gilbert-type) delta systems formed. The decrease in thickness and lateral extent indicates a rapid upslope shift of depocentres. A high rate and magnitude of lake-level fall (50 m) promoted the development of a single incised valley and the deposition of forced regressive coarse-grained delta lobes in front of the valley. The incised valley was filled during decreasing rates of lake-level fall and low base-level, because the alluvial gradient was larger than the emergent lake profile. Attached sand-rich forced regressive aprons formed during lower magnitudes of lake-level falls in the range of 30–35 m. Valley incision occurred, but was limited to the uppermost portion of the delta, controlled by the steep slope. The incised valley related to the final lake drainage is associated with long-wavelength (60–90 m) bedforms at the downslope end, attributed to the formation of standing waves as a result of a hydraulic jump. Estimated palaeoflow depth during standing wave formation was ∼9–14 m and flow velocity was 10–12 m s−1. Because subsidence, waves or tides did not play a major role, the Emme delta can be used as an analogue-based predictive stratigraphical and sedimentological model for steep glacigenic deltas controlled by rapid base-level change and can help to understand better the facies distribution and three-dimensional geometry of these depositional systems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.