Research on the Microstructure and Mechanical Properties of Repaired 7N01 Aluminum Alloy by Laser-Directed Energy Deposition with Sc Modified Al-Zn-Mg

Abstract

Aluminum alloy is an important material used in railway train structures. It is of great significance to repair aluminum alloy through directional energy deposition to reduce cost and improve the performance of the aluminum alloy. In this study, 7N01 aluminum alloy was repaired by means of laser-directed energy deposition (DED) with the powder of Sc-modified Al-Zn-Mg aluminum alloy as raw material. The microstructure and mechanical properties of the repaired specimens were studied through the metallographic microscope, scanning electron microscope, electron backscatter diffraction, universal tensile test, and Vickers hardness test in combination. The results show that the bonding interface of the repaired aluminum alloy is satisfactory, and the porosity is 2.8%. The grains in the repaired area are the columnar crystals growing vertically along the boundary of the melt pool with an obvious temperature gradient. Fine equiaxed crystals are distributed along the boundary of the melt pool, and Al3(Sc,Zr) particles play a role in grain refinement. The average grain size of the fine grain area in the repair zone next to the fusion zone is 9.1 μm, and the average grain size of the coarse grain area is 20 μm. The average tensile strength in the area of repair approaches 349 MPa, which is 91% that of the base material, and the elongation rate is 10.9%, which is 53.2% that of the base material. The hardness ranges between 122 HV and 131 HV, which is comparable to the base material. However, there is a significant decrease in the tensile strength and hardness of the base material (heat-affected zone).