Abstract
For EUV lithography, a reflective mask is essential because of use of the strong energy, wavelength of 13.5 nm. The EUV mask consists of multi-layered, multi-material structure and is susceptible to various contaminants. Since EUV lithography process should be used in a high vacuum environment, an electrostatic chuck (ESC) is used to fix or hold the EUV mask using electrostatic force. In general, in order to use ESC chuck, it needs a thin conductive layer (CrN layer) on the backside. However, the contact points of the electrostatic pin chuck can make exfoliation of conductive CrN layer producing CrN particles. If these particles are present on the backside of the mask, CD or DOF may be affected during EUV exposure. The 1 μm particle can leads to a gap radius of 42mm [4]. Moreover, these backside particles may travel to the front side. Therefore, backside cleaning should be performed to remove particles from the mask backside surface.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
