Reduction in the interface-states density of metal-oxide-semiconductor field-effect transistors fabricated on high-index Si (114) surfaces by using an external magnetic field

Abstract

After fabrication of Metal-Oxide-Semiconductor Field-Effect Transistor (MOSFET) devices on high-index silicon (114) surfaces, their threshold voltage (Vth) and interface-states density (Dit) characteristics were measured under the influence of an externally applied magnetic field of B = 6 μT at room temperature. The electron flow of the MOSFET's channel presents high anisotropy on Si (114), and this effect is enhanced by using an external magnetic field B, applied parallel to the Si (114) surface but perpendicular to the electron flow direction. This special configuration results in the channel electrons experiencing a Lorentzian force which pushes the electrons closer to the Si (114)-SiO2 interface and therefore to the special morphology of the Si (114) surface. Interestingly, Dit evaluation of n-type MOSFETs fabricated on Si (114) surfaces shows that the Si (114)-SiO2 interface is of high quality so that Dit as low as ∼1010 cm−2·eV−1 are obtained for MOSFETs with channels aligned at specific orientations. Additionally, using both a small positive Vds ≤ 100 mV and B = 6 μT, the former Dit is reduced by 35% in MOSFETs whose channels are aligned parallel to row-like nanostructures formed atop Si (114) surfaces (channels having a 90° rotation), whereas Dit is increased by 25% in MOSFETs whose channels are aligned perpendicular to these nanostructures (channels having a 0° rotation). From these results, the special morphology of a high-index Si (114) plane having nanochannels on its surface opens the possibility to reduce the electron-trapping characteristics of MOSFET devices having deep-submicron features and operating at very high frequencies.