Abstract
In the present investigation, the reduction and swelling behaviors (in low grade coal) of fired iron ore pellets, prepared by blending hematite iron ore fines of −100, −18 + 25, and −10 + 16 mesh sizes in different proportions, have been studied in the temperature range of 850–1000°C with an objective to promote massive utilization of fines in sponge ironmaking. An increase in temperature up to the range studied (850–1000°C) substantially enhanced the reduction rate and the rate was found to be highest in the first 15–30 min at all these temperatures. All the fired pellets, made by mixing iron ore particles of ± 100 mesh size, have shown approximately the same reduction rates and slightly higher swelling indices than those made from fines of −100 mesh size only. In all the fired pellets reduced at temperatures of 850°C and 900°C, the results indicated an increase in the extent of swelling with reduction time. Reduction of fired pellets at temperatures of 950°C and 1000°C exhibited shrinkage in their reduced products, and the extent of this shrinkage increased with increase in exposure time.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Mineral Processing and Extractive Metallurgy Review
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
