Abstract
Metal films deposited on polydimethylsiloxane (PDMS) substrates frequently exhibit wrinkles and cracks, which is a problem in fabricating flexible electronics. Here, we present the result of a study investigating the influence of the PDMS surface roughness, surface free energy and wettability on the quality of metal films and explored methods to reduce those wrinkles and cracks. Initially, the low molecular weight chains (LMW) in PDMS substrate were extracted by hexane solution. After extraction, the PDMS was etched in an oxygen plasma and the metal was deposited. Both surface roughness measurements and microscopic photographs demonstrated that Cu film deposited on the pretreated PDMS substrate exhibited less wrinkles and cracks than on native PDMS substrate. Finally, to demonstrate the effectiveness of the wrinkle improvement, a flexible dry electrode with micro domes was fabricated and used for Electro Cardio Gram (ECG) recording. The results showed that the fabricated dry electrode with reduced wrinkles produced good ECG signals with distinct P, QRS, and T waves.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
