Abstract
Carbon foams with high compressive strength and low thermal conductivity were produced using coal tar pitches (CTPs) obtained from low-temperature coal tar (LTCT), after thermal treatment combined with vacuum distillation technology and selective solvents. Pyrolysis behavior and the chemical composition of CTPs were investigated by elemental analysis, thermogravimetric analysis, Fourier transform infrared and X-ray photoelectron spectroscopy. Investigation of the relationship between the properties of the precursors and the structure of the obtained foams indicated that the pyrolysis behavior and composition of the precursors significantly affected the foaming process, and the structure and thermal conductivity of the foam. The experimental results showed that the structures and characteristics of the carbon foams could be controlled by adjusting the chemical composition of the precursors. In addition, carbon foams with honeycomb-type, open-cell structures, and ordered lamellar ligaments were produced from CTPs with the lowest HS and TI contents by treatment with toluene, and showed a low thermal conductivity of 0.039 W/m·K. Carbon foam without microcracks was obtained from CTPs with the highest HS contents produced from LTCT modified by N, N-dimethyl formamide, which showed a compressive strength of 6.580 MPa.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.