Abstract
The effect of heat-treatment conditions on the corrosion behavior of yttria stabilized zirconia (YSZ) coated AISI-type 316L stainless steels in molten carbonate are investigated. YSZ films on stainless steel were prepared by the sol-gel method. While the sample heat-treated at 800°C for 2 hours in air has an uneven surface microstructure with macrocracks, a YSZ coated sample heat-treated in argon has an even microstructure. The polarization resistance and corrosion rate of YSZ coated sample heat-treated in air were deteriorated from 6.948 Ωcm2 and 364.7 mpy (millimeter per year) to 3.291 Ωcm2 and 769.8 mpy, respectively, by the corrosion for 100 hours due to its poor surface microstructures. At the same experimental condition, meanwhile, those corrosion parameters of YSZ coated sample heat-treated in argon were 15.43 Ωcm2 and 164.2 mpy, respectively, and those were improved to 18.83 Ωcm2 and 134.6 mpy after the corrosion for 100 hours. This is attributed to the YSZ film with well developed surface microstructures. The concentration profiles of elements and X-ray diffractograms indicate that the oxide layer of YSZ coated sample heat-treated in argon had a triple layer structure composed of outer YSZ film, in between Fe2O3 layer, and inner chromium rich layer during corrosion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.