Preparation of high‐strength lightweight alumina with plant‐derived pore using corn stalk as pore‐forming agent

Abstract

AbstractTo improve the mechanical and thermal insulation properties of lightweight alumina, which was prepared by using pore‐forming agent from biological sources, the silica sol‐infiltrated corn stalk was utilized. Spring back and hygroscopicity of corn stalk powder as well as cold compressive strength, thermal conductivity, microstructure, and pore size distribution of lightweight alumina were characterized. The results indicate that impregnation of silica sol leads to different degrees of decrease in spring back height due to achieving better mesh by silica gel between the corn stalk powders, and then improves the formability, although at the same time the large number of hydrophilic groups results in an increase in hygroscopicity. Furthermore, sol impregnated pore‐forming agent optimizes the microstructure of the lightweight alumina pores. Lightweight alumina with a cold compressive strength up to 48.64 MPa was produced, and with the silica sol concentration of 3 wt%, lower thermal conductivity values at all test temperatures were obtained. Hence, the use of corn stalk impregnated with the appropriate concentration of silica sol as pore‐forming agent could enhance the mechanical and thermal insulation properties of lightweight alumina for the spheroidization of pore shape, randomization of pore distribution as well as miniaturization of pore size.