Preparation of Biomass-Derived High Specific Surface Area Carbon with Titanium Nitride Nanoparticles for Lithium-Sulfur Batteries

Abstract

The widespread challenges facing lithium-sulfur batteries, including the low electrical conductivity of sulfur and its species, electrode volume fluctuations during cycling, and the lithium polysulfides shuttle effect, have hindered their commercialization and practical utility [1,2].Our study addresses these issues by incorporating titanium nitride (TiN) nanoparticles onto high specific surface area porous carbon, exploring this composite's potential as both a sulfur cathode host and separator modifier. The synthesis of the carbon/TiN composite involved two key stages: firstly, the in-situ growth of titanium dioxide (TiO2) nanoparticles on the carbon surface utilizing titanium tetrachloride as a precursor; secondly, the conversion of the TiO2 nanoparticles to TiN nanoparticles through carbothermal nitridization (thermal treatment at 1400 ℃ for 4 hours in a nitrogen medium) [3,4].The lithium-sulfur cell employing the prepared C/TiN-25%@S cathode exhibited an initial discharge capacity of 1155 mAh g-1 at 0.2 C, maintaining a capacity exceeding 700 mAh g-1 after 100 cycles. Notably, the lithium-sulfur cell utilizing the C/TiN-25%@S cathode and a C/TiN-modified separator demonstrated enhanced cycling performance, delivering an initial discharge capacity of 1623 mAh g-1 with retention of over 1126 mAh g-1 after 100 charge/discharge cycles at 0.2 C. Acknowledgments This research was funded by the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan (Grant No. AP19677708).