Predictive analytical modeling of cutting forces generated by high-speed machining of ductile and hard metals

Abstract

ABSTRACTThis paper proposes an analytical cutting forces model based on an extension of the Oxley's machining theory (OMT) to high-speed machining of ductile and hard metals. In this model, the materials' behavior was modeled using the Marusich's constitutive equation (MCE). Furthermore, The OMT was modified to be able to capture the effects of the cutting tool edge radius and the burnishing phenomenon by implementing a variable rake angle equation and the Briks criterion, respectively. The predictive model was validated using experimental data obtained during the orthogonal machining of two aluminum alloys (AA6061-T6 and AA7075-T651) and induction-hardened AISI4340 steel (58-60 HRC). The results showed that the predicted and experimental cutting forces were in reasonable agreement for all tested materials. The strain rate constant in the primary shear zone (C0) was found to be significantly sensitive to the cutting conditions and work material, and its effect on the predicted data was highlighted and discussed in depth. On one hand, it was found that AA6061-T6 is less sensitive to the strain rate compared to the AA7075-T651. On the other hand, all tested materials were found to be more sensitive to the strain rate at low cutting speeds and/or cutting feeds.