Precision electrochemical machining of tungsten micro-rods using wire electrochemical turning method

Abstract

The novel wire electrochemical turning (WECT) method has been proposed to machine tungsten with neutral electrolyte and bipolar pulse current in the authors’ previous research. The influence of tool wear caused by the bipolar pulse current, which is needed to remove the oxide layer generated on tungsten surface when using a neutral electrolyte, was eliminated by the WECT method because the wire tool electrode was kept being wound during the machining process. In this paper, the influences of the most important process parameters, such as the kind of electrolyte, wire material, wire diameter, rotation speed of the workpiece rod, and frequency of the pulse voltage, were studied to understand the fundamental aspects of the WECT method and improve the machining efficiency of tungsten micro-rods. The experimental results showed that the NaCl electrolyte and the NaNO3 electrolyte had higher machining efficiency and better machining accuracy, respectively. The machining accuracy was improved with the SUS304 stainless steel wire used as tool electrode than the brass wire tool electrode. It was also found that the machining efficiency and accuracy were improved with decreasing the wire diameter and increasing the rotation speed of workpiece because the influence of stray current flowing through the side and end surface of machined micro-rod was reduced. The machinable length of micro-rod peaked at an optimum feed speed of the workpiece, and the optimum speed increased with increasing the frequency of pulse voltage. As a result, a minimum rod diameter of 11 μm was fabricated with a high aspect ratio of 36. Compared with the previous method using a platinum film as tool electrode, the aspect ratio was increased significantly because the influence of tool wear was eliminated.