Abstract
The effects of carbon dioxide (10.6 μm) and argon fluoride excimer (193 nm) lasers as preadhesion surface treatments for polycarbonate and polyetherimide were studied. Single lap shear specimens bonded with a flexible polyurethane adhesive were utilized to investigate the effect of the various laser treatments on final shear properties and mode of failure. Experimental results based on mechanical properties, scanning electron microscopy and Fourier transform infra-red have indicated that the excimer laser is more effective than the carbon dioxide laser with respect to shear properties and the level of adhesion obtained with the thermoplastic adherends and polyurethane adhesive studied. Polycarbonate with its lower glass transition temperature T g was affected by the carbon dioxide laser to a higher extent than the higher T g polyetherimide. Furthermore, polycarbonate exhibited enhanced shear properties and a higher level of chemical modification following excimer laser irradiation compared to polyetherimide.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
