Plastic Shavings by Laser: Peeling Porous Graphene Springs for Multifunctional All-Carbon Applications.

Abstract

Manufacturing strategies to create three-dimensional (3D) structures with multifunctional nanomaterials are of intense interest for fabricating building blocks in many electromechanical applications. A coil spring composed of graphene provides an important step toward the realization of all-carbon devices, as it is one of the essential elements for a wide range of systems. In this connection, here an unprecedented fabrication strategy to create a new type of 3D coil spring composed of laser-induced graphene springs (LIG-S) which is spontaneously produced via the pyrolytic jetting technique, is presented. Similar to wood or metal shavings observed in traditional machining processes, a pair of LIG-S with two opposite chiralities and controllable macroscopic dimensions is produced by a single scanning of a focused continuous-wave (CW) laser on a polyimide (PI) substrate. The resulting LIG-S, plastic shavings by laser, exhibits sufficient mechanical and electrical properties to enable many applications including strain-tolerant spring electrodes, antennas, supercapacitors, gas sensors, and luminescent filaments under extreme conditions. Without using any conventional fabrication techniques or other labor-intensive, time-consuming, and expensive processes, this novel approach enables a high-throughput mass production of macro-, micro-, and nanoscale featured LIG-S that can be manufactured within seconds to realize many open opportunities in all-carbon electromechanical systems.