Physiological and biomechanical differences between wheelchair-dependent and able-bodied subjects during wheelchair ergometry

Abstract

The purpose of this study was to compare the physiological and biomechanical responses of wheelchair-dependent persons (WCD) to able-bodied persons (AB) during manual wheelchair ergometry. Five WCD and five AB performed a discontinuous wheelchair ergometer test starting at 12.8 W at 30 rev.min-1 (57 m.min-1) with increments of 7.0 W at 6-min intervals. Biomechanical data were collected 3.5 min into each stage followed by the collection of physiological data. After the fifth stage, peak oxygen consumption was determined by having the subject work against a resistance of 14.7-19.6 N at 30 rev.min-1. The WCD had significantly higher net mechanical efficiency at 26.7, 33.6 and 40.6 W in comparison to the AB. The WCD had significantly greater shoulder extension at the point of initial wheel contact as measured by the shoulder angle, while the AB had significantly greater shoulder range of motion at all work rates in comparison to the WCD. The results demonstrate that a significant physiological difference exists in the manner by which WCD and AB accomplish wheelchair ergometry. The biomechanical differences between AB and WCD were found to be a prominent factor contributing to the higher mechanical efficiency of WCD over AB. It was concluded that basic physiological and biomechanical differences exist between WCD and AB in manual wheelchair locomotion and that these differences are important considerations to the interpretation of data in wheelchair ergometry studies.