Phosphorylcholine Group-immobilized Surface Prepared on Polydimethylsiloxane Membrane by In Situ Reaction for Its Reduced Biofouling

Abstract

To reduce interactions between biological molecules and the surface of microchip devices including the microchip, which should be conducted to improve sensitivity, reactivity, and the typical phospholipid polar group, the phosphorylcholine group-immobilized surfaces were prepared. The surface modification of polydimethylsiloxane (PDMS) was performed by in situ reaction during curing by cross-linking the PDMS prepolymers. Since it is known that 2-methacryloyloxyethyl phosphorylcholine (MPC) facilitates the preparation of biomedical polymers with excellent biocompatibility and antithrombogenicity, it was used as the reactant for surface modification. The MPC was coated on the glass substrate, and two-liquid-type PDMS prepolymers were then applied. During the curing process of the vinyl groups of poly(dimetylsiloxane-co-methylsiloxane) and poly(dimethylsiloxane-co-methylvinylsiloxane), the methacrylate group in MPC was attached onto the PDMS surface via a hydrosilyl group. Analysis of the surface characteristics by X-ray photoelectron spectroscopy and measurement of the surface contact angle revealed that the introduction of the phosphorylcholine group in the MPC unit on the surface induced hydrophilicity at the surface. Further, protein adsorption on the surface decreased with an increase in the number of phosphorylcholine groups. Based on these results, we concluded that the construction of the phosphorylcholine group-enriched surface on the PDMS substrate could be achieved by immobilization of MPC, and it may facilitate fabrication of biomedical devices, particularly microfluidic devices.