Abstract
Adhesive and screw connections are usually used in single lap connections for coldformed steel. In this study, the work focuses on the joints strength of connection for both adhesive and self-drilling screw on tensile performance. Experimental investigations were conducted on the single lap joints design. The average failure load (joints strength) of adhesive connections was found to be 50% higher than the screws joints. More often than not, the joint effectiveness of adhesive is based along the area of adhesive meanwhile for screw depends on the number of screws used.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
